Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for DeLonghi FEB2262.B
Summary of Contents for DeLonghi FEB2262.B
- Page 1 FEB22XY BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for Use...
- Page 3 page 4 Decalci cante per macchine da ca è Descaler for co ee machines Détartrant pour machines à café Entkalker für Ka eemaschinen De’Longhi Appliances s.r.l. Via L. Seitz, 47 31100 Treviso - ITALY Tel. +39 0422 4131 5413218631/04.15 ✕ ✕...
-
Page 4: Table Of Contents
CONTENTS 15. CLEANING THE INFUSER ......19 1. INTRODUCTION ........5 16. DESCALING ...........19 1.1 Letters in brackets ........5 17. EXPLANATION OF LIGHTS ......21 1.2 Troubleshooting and repairs ....5 18. TROUBLESHOOTING ......23 2. DESCRIPTION ......... 5 19. TECHNICAL DATA ........25 2.1 Description of the appliance - A ....5 2.2 Description of control panel - B ....5 2.3 Description of indicator lights - C ....5 2.4 Description of accessories - D* ....5... -
Page 5: Introduction
Indicator blinking: grounds container not in position If repairs are required, contact De’Longhi customer services C5. Descale indicator: only. Addresses can be found on the website www.delonghi. Indicator permanently alight: machine needs descaling com. Indicator blinking: descaling in progress 2. -
Page 6: Setting Up The Appliance
MAX level with fresh drinking water (fig. 4), then filter. reposition in the appliance. For more information, visit the www.delonghi.com website. EAN: 8004399327252 To use the filter correctly, follow the instructions below. 1. Remove the filter (D4) from the pack and turn the date... -
Page 7: Replacing The Filter
0,5 L 2. To activate the filter, run drinking water through the hole 11. The appliance delivers hot water, stopping automatically; in the centre of the filter until water comes out of the 12. When the flow stops, the filter indicator light extinguish- openings at the side for more than a minute (fig. -
Page 8: Turning The Machine On
according to the actual hardness of the local water supply. The appliance is ready for use when the drinks and intensity Proceed as follows: Leds remain permanently alight. 7. TURNING THE MACHINE OFF Whenever the machine is turned off after being used to make coffee, it performs an automatic rinse cycle. -
Page 9: Making 2 Cups Of Coffee
Drink D e f a u l t Programmable q u a n t i t y quantity (ml) (ml) from ≃ 20 to ≃ from ≃ 100 to ≃ 3 16 from ≃ 80 to ≃ 3. Place a cup under the coffee spouts (A16) (fig. 15); 4. -
Page 10: Rinsing
2. Select the desired coffee drink. For a fuller bodied and Turn one click toward num- Please note: creamier coffee ber “1” • When the next coffee is made, the machine will show the The effect of this adjustment will last intensity setting selected. -
Page 11: How Much Milk
Whole (fat >3,5%) Semi-skimmed ✓ (fat between 1.5 and 1.8%) Skimmed (fat <0.5%) Vegetable drinks ✓ Soya 3. Fill the milk container (E7) with suitable quantity of milk ✓ Almond (fig. 17 and 20); ✓ Oatmeal 4. Make sure the milk intake tube (E4) is secured correctly to the socket on the underside of the milk carafe lid (fig. -
Page 12: Delivering Milk-Based Drinks
of the coffee” or alternatively, select pre-ground coffee (and in this instance, proceed to add one measure of coffee as indicat- ed in section “8.3 Making coffee using pre-ground coffee ”). 9.5 Delivering milk-based drinks 1. Place a cup of suitable size under the coffee spouts (A16) and under the frothed milk spout (E3) (fig. -
Page 13: Delivering Hot Water
2. Once the cup is filled to the desired level, press the drink but- 4. Delivery will stop automatically. To terminate the delivery ton a second time: delivery of the first ingredient stops and sooner, press the button a second time. delivery of the second ingredient begins;... - Page 14 1. Access the menu: Press and hold the button for a few seconds: the buttons used for selecting settings will light up. Proceed by pressing the button for the setting to be changed. 2. Change the machine settings: Water softener filter Confirm selection FILTER IN PLACE Press the intensity button...
- Page 15 Energy saving Confirm selection Press the intensity button ENABLED repeatedly until the Leds relative to the desired setting light up DISABLED LEVEL 1 Water hardness Confirm selection Press the intensity button repeatedly until the Led corresponding to the LEVEL 2 required level lights up LEVEL 3 LEVEL 4...
-
Page 16: Restore Factory Settings
12.1 Restore factory settings Make sure the machine is in stand-by (off, but connected to the mains power supply). Press the drinks buttons 1, 2 and hold for 5 seconds: all settings and drink quantities will be reset to the default factory values. - Page 17 Component Frequency Procedure Grounds container • Remove the drip tray, empty and clean. indicator lights up, the When the • Empty the grounds container and clean thoroughly grounds container must be emptied: the to remove all residues that may have collected on machine cannot now make coffee.
-
Page 18: Thorough Cleaning Of Milk Carafe
14. THOROUGH CLEANING OF MILK CARAFE immerse all the components in a solution of hot drinking water (at least 40° C) and washing up liquid for at least 30 VERY IMPORTANT minutes. Rinse all the components described above thor- To ensure optimum results are obtained from oughly under hot drinking water, rubbing each one individ- the Lattecrema system over time, clean the ually between fingers and thumbs. -
Page 19: Cleaning The Infuser
milk container (E7) then turn toward the symbol until locked (fig. 22). 15. CLEANING THE INFUSER Clean the infuser (A6) regularly, at least once a month. Important! The infuser (A6) cannot be removed while the machine is on. 1. Press the button (B1)to turn the machine off;... - Page 20 Step 2: First rinse Step 1: Descaling action 8. Empty the container used to collect the descaler solution. Re- move and empty the water tank, rinse under running water, 2. Press the button (B5) and hold for at least 5 sec- then fill with fresh drinking water up to the MAX level (fig.
-
Page 21: Explanation Of Lights
15. The “no water” indicator (C2)lights up: remove the tank Indicator/Led Meaning and fill with fresh drinking water. Reposition the water General alarm: the inside of tank in the machine. the machine is very dirty. The machine is ready for use. Clean the machine thor- Please note: oughly. - Page 22 Indicator/Led Meaning Indicator/Led Meaning Too much coffee has been Hot water has been select- used. Select a milder inten- ed, but the spout is not in sity or reduce the quantity place: fit the water spout of pre-ground coffee Hot water The coffee emerges too slowly or drop-by-drop..
-
Page 23: Troubleshooting
Indicator/Led Meaning Indicator/Led Meaning Descaling has been inter- Descaling in progress rupted. Complete the cycle, restarting from the step indicated by the intensity selection Leds. Installation/Replacement of water filter softener progress → 18. TROUBLESHOOTING Possible malfunctions of the machine are listed below. If the problem cannot be resolved as described, contact Customer Service. - Page 24 Problem Cause Solution The coffee emerges too slowly or Coffee ground too finely. Adjust the grinding level (“8.8 Adjusting drop-by-drop. the coffee mill”). The effect will not be noticeable until at least 2 coffees have been made. The machine does not deliver coffee. Impurities have been detected in the in- Wait until the machine is ready for use ternal circuits...
-
Page 25: Technical Data
Problem Cause Solution The machine emits puffs of steam from The drip tray grille has not been replaced Ensure the grille is repositioned in the the drip tray and/or there is water on the after cleaning. drip tray. surface where the machine is positioned. 19. - Page 28 De’Longhi Appliances via Seitz, 47 31100 Treviso, Italy www.delonghi.com...