DeLonghi FEB2262.B Instructions For Use Manual page 24

Problem
The coffee emerges too slowly or
drop-by-drop.
The machine does not deliver coffee.
Coffee does not come out of one or both
spouts.
The coffee delivered is watery.
The infuser cannot be removed.
With the descaling procedure completed,
the appliance prompts for a third rinse
The milk presents large bubbles, or
splashes from the spout(E3) , or is
under-frothed.
Milk-based drinks are not enabled
The cup tray on top of the machine is hot Several drinks have been prepared in
The machine emits noises or small puffs
of steam while not in use
Cause
Coffee ground too finely.
Impurities have been detected in the in-
ternal circuits
Coffee nozzles blocked.
Pre-ground coffee funnel clogged.
The machine has not been correctly
switched off.
During the two rinse cycles, the water
tank was not filled to the MAX level
Milk is not cold enough, or is not semi-
skimmed or skimmed.
Milk carafe lid dirty.
Vegetable drinks are being used.
Milk carafe missing or not correctly in
place.
Several milk drinks have been prepared
in succession and the machine needs to
heat up to the right temperature in order
to make the next drinks.
rapid succession
The machine is ready for use or has just
been turned off, and a few drops of
condensate are falling into the steamer,
which is still hot.
24
Solution
Adjust the grinding level ("8.8 Adjusting
the coffee mill"). The effect will not be
noticeable until at least 2 coffees have
been made.
Wait until the machine is ready for use
again, and proceed to select the required
drink. Contact an authorized Service Cen-
tre if the problem persists.
Clean the nozzles with a cloth. Any en-
crusted deposits can be removed with a
toothpick, if necessary.
Open the flap and clean the funnel with
the aid of a brush.
Switch the machine off by pressing the
button.
Restart the descaling procedure from
"Step 3: Second rinse".
Use skimmed or semi-skimmed milk
straight from the refrigerator (tempera-
ture about 5° C). If the result is still not as
expected, try changing the brand of milk.
Disassemble the components and clean
thoroughly as described in section "9.6
Cleaning the milk carafe after each use".
Take particular care when cleaning the
milk carafe connector (E6).
The end-result varies widely depend-
ing on the nutritional properties of the
drinks. "Barista" versions of these drinks
are recommended.
Prepare the milk carafe and position it
correctly in the machine.
Wait until milk-based drinks are again
enabled on the control panel.
This is to be expected as an aspect of
normal operation: to minimize the effect,
empty the drip tray regularly.
→