Table of Contents
Advertisement
according to the actual hardness of the local water supply.
Proceed as follows:
1. If a total hardness test strip (D1) is supplied with the
model of machine in question, remove it from its wrapper.
2. Immerse the strip completely in a glass of water for about
one second (fig. 12).
3. Remove the strip from the water and shake lightly (fig.
13). After about a minute, 1, 2, 3, or 4 red squares appear,
depending on the hardness of the water. Each square cor-
responds to one level.
Total Hardness Test
See instructions in section "12. Settings menu" to set the ma-
chine accordingly.
6. TURNING THE MACHINE ON
Danger of scalding!
During the rinse, a little hot water flows from the coffee spouts
(A16). Take care to avoid contact with splashes of water. To
avoid the need for frequent emptying of the drip tray (A14),
place a container under the spouts to collect the rinse water.
•
To switch on the machine, press the
the Led of the on/off button lights up and the drinks Leds
blink on the control panel (B) to indicate that the machine
is warming up.
During this step, the machine performs a rinse cycle. Besides
heating up the boiler, this also serves to circulate hot water
through the internal circuits so they too are brought up to
temperature.
12
Hardness
1
Low
2
Medium
3
Medium/High
4
High
button (B1):
The appliance is ready for use when the drinks and intensity
Leds remain permanently alight.
7. TURNING THE MACHINE OFF
Whenever the machine is turned off after being used to make
coffee, it performs an automatic rinse cycle.
Danger of scalding!
During the rinse, a little hot water flows from the coffee spouts
(A16). Take care to avoid contact with splashes of water. To
avoid the need for frequent emptying of the drip tray (A14),
place a container under the spouts to collect the rinse water.
•
To switch the machine off, press the
13
•
the drinks indicator Leds on the control panel will now
blink: the appliance performs a rinse cycle, if envisaged,
and then switches off (stand-by).
7.1 Switching off for extended periods:
If the machine is not going to be used for any length of time
(e.g. holidays, periods of absence), proceed as follows:
•
turn off the machine by pressing the
•
empty out and clean the grounds container (A10) and the
water tank (A9);
•
unplug the power cord (A7) from the socket.
Please note:
When turning the machine on again, fill the water tank and,
before making any kind of drink, run 3 rinse cycles as indicated
in section "8.6 Rinsing".
8. MAKING COFFEE DRINKS
8.1 Makingcoffee using coffee beans
Important!
Do not use green, caramelized or candied coffee beans as they
could stick to the coffee mill and make it unusable.
1. Fill the container (A3) with coffee beans (fig. 14);
2. Place a cup under the coffee spouts (A16) (fig. 15);
3. Lower the spouts as near as possible to the cup: this
makes a creamier coffee (fig. 15);
4. Select the required drink:
8
button (B1);
button (B1);
14
15
Advertisement
Table of Contents
Troubleshooting
