Table of Contents
Advertisement
Registration
Registering the i 5803 Handset for the first time
After charging, the screen will display:
If your Base Unit is model i 5866 or i 5867:
1)
Fine the Base ID Code on the underside of the
Base Unit.
2)
Enter the 15-digit Base ID Code into the Handset. If you make a mis
-take, press the left NavKey to backspace or press the right softkey
to erase a character.
3)
Press OK to complete the registration process.
If your Base Unit is model i 5853 or i 5857, find the Base ID Code (Base Unit
must be OFF) and register the Handset by:
1)
At the Base, press MENU.
2)
Scroll down to DISPLAY BASE-ID, then press OK.
3)
Enter the 15-digit Base ID Code into the Handset. If you make a
mistake, press the left NavKey to backpace or press the right softkey
to erase a character.
4)
Press OK to complete the registration process.
NOTE: If the Handset, after charging, says Searching for Base..., press the
NEW softkey. Enter Base ID will now be displayed. Follow the steps above.
Wait approximately 15-60 seconds. You will hear confirmation beeps from the
Base and Handset. The newly registered Handset will now be assigned the
lowest extension number not previously assigned to a different system Hand-
set (1 - 8).
If you do not enter the correct digit sequence, you will see Invalid Base ID! and
hear an error tone. Press the left NavKey to backpace or press the right
softkey
to erase a character, and carefully re-enter the Base ID Code.
NOTE: The 15-digit BASE ID Code may contain numbers and characters,
including *. Make sure you carefully enter all 15 digits.
8
Advertisement
Table of Contents
