Check For Dial Tone; Tone/Pulse Selection; Removable Face Plates - VTech gz 2456 Operating Instructions Manual

Check for Dial Tone

After the batteries are charged, connect the modular telephone cord between a live
phone jack and the jack located on the bottom of the Base Unit. Pick up the Handset and
press PHONE. You should hear a dial tone.

Tone/Pulse Selection

Your gz 2456 is preset for tone dialing. S e e "Telephone Operation" for details.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF YOUR
CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and Extension Handsets away
from electronic equipment, such as personal
computers, television sets and microwave ovens.
3. In locations where there are multiple cordless
telephones, separate base units as much as possible.
4. Install your telephone equipment away from heat
sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.

Removable Face Plates

Your gz 2456 comes with additional Handset and Base Plates of various colors. You can
interchange these plates to suit your personal tastes and room decor.
Handset Face Plate
Carefully remove the Handset face plate by prying up from the notch at the bottom of the
plate. Re-attach by snapping the upper portion of the plate into position first, then snapping
the lower portion into position.
Base Face Plates
Carefully remove the two Base plates by prying up from the notches located at the
bottom front and back edge of the plate. Align the new Base plates, making sure the
antenna passes through the appropriate slot. Secure the plates by snapping it into position.
Remove
Remove
Re-attach
Re-attach
5
Setup