Keystone KSTAP10PINV User Manual page 20

3. Insert the window slider assembly into the
window track. If the hose opening is covered
by the window frame, rotate the panel so the
thicker side faces the window frame. (see Fig.9)
For some units, attach the Window Kit Brace
to the back of the hose panel to brace against
the window so the window slider panels do
not lean inward.(see Fig.10)
4. Be sure bolts are installed in both sides of the
window slider for improved rigidity.
5. Cut the non-adhesive foam seal C strip to match
the window height. Insert the foam seal between
the glass and the window frame to prevent air
and insects from getting into the room.(see Fig.11)
6. If desired, install the security bracket with 2 screws
as shown.(see Fig.12)
7. Attach the Sliding Window Adapter to the hose by
lining up the circles on the adapter the hose. Insert
the window slider adapter into the hole of the window
slider.(see Fig.13)
Page 16
 
Window slider B
(if required)
Window slider A
Fig.9
Window
Kit Brace
Foam seal C
(Non-adhesive type)
Security
Bracket
2 Screws
基准说明同时展示PD所有全
求，可根据订单BOM中的实
Fig.10
Fig.11
Fig.12
Fig.13