1.
Align the hole in the lower handle with the hole
in the upper handle, then insert the bolt from outside,
and then tighten the thumb nut from inside. Perform the
same procedure on the other side.
1
Fig.1
► 1. Bolt 2. Thumb nut 3. Lower handle 4. Upper
handle
2.
Turn the knob 90° while pulling the knob on the
lower handle to release the locking pin. Perform the
same procedure on the other side. Raise the handle,
and then turn the knob on both sides 90°. Make sure
that the knobs are securely fixed.
Fig.2
► 1. Knob
2
2
3
4
1
NOTE: Supporting the handle makes it easier to
release the locking pin when pulling the knob.
NOTE: When turning the knob, be careful not to get
the cord caught in the knob.
Fig.3
► 1. Knob
Removing the mulching plug
1.
Open the rear cover.
Fig.4
► 1. Rear cover
9 ENGLISH
1
1