Makita GA7082 Instruction Manual page 9

For tool with locking screw type
wheel guard
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work. Be
sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
1
2
Fig.7
► 1. Wheel guard 2. Bearing box 3. Screw
For tool with clamp lever type wheel
guard
Optional accessory
WARNING:
The wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
Loosen the nut, and then pull the lever in the direction
of the arrow.
2
Fig.8
► 1. Nut 2. Lever
3
1
9 ENGLISH
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work.
1
2
Fig.9
► 1. Wheel guard 2. Bearing box
Fig.10
► 1. Wheel guard
Securely tighten the nut using a spanner, and then
close the lever in direction of the arrow to fasten the
wheel guard. If the lever is too tight or too loose to
fasten the wheel guard, open the lever and then loosen
or tighten the nut using the spanner to adjust the tight-
ening of the wheel guard band.
Fig.11
► 1. Nut 2. Lever
To remove wheel guard, follow the installation proce-
dure in reverse.
1
1
2