Table of Contents
Advertisement
Operating Instructions
Changing Channels
•
If you notice interference while on a call, press
CHAN to switch to a clearer channel.
TONE/PULSE Setting
• If you have touch tone service, press PROG,
*, *, MEM to switch to TONE dialing.
• If you have rotary service, press PROG, *, #,
MEM to switch to PULSE.
NOTE: Your t 2408 is preset at the factory for
TONE dialing.
Temporary Tone
If you have rotary (pulse) telephone service, this
feature allows you to enter special codes and tones
to use electronic banking services, calling cards,
or other special services.
• Dial the number as you normally would.
• Press
(tone). This will activate the temporary
*
tone feature.
• Keys pressed after this will send touch tone
signals.
• To end the call, press OFF or place the handset
back in the base. The phone will automatically
go back to rotary service.
Programming Ringer Type
You can choose from four ring tones or turn the
ringer off to extend the battery life.
• Make sure the handset is OFF, press PROG.
• Press the # key.
• Press a key 1 - 4 to select a ringer type.
-OR-
• Press 5 to turn the ringer off.
• Press MEM to confirm your selection.
Checking Ringer Type
To check the ringer that is currently programmed:
• Press PROG.
• Press the # key.
• Press 0.
• Press MEM to confirm.
10
Advertisement
Table of Contents
