Changing Channels; Tone/Pulse Setting; Temporary Tone; Programming The Ringer Type - VTech TeleZapper VT2558 Operating Instructions Manual

Operating Instructions

Changing Channels

• If you notice interference when using your
Handset, press CHAN to switch to a clear channel.
This function is only available when you are on
a call.

TONE/PULSE Setting

NOTE: Your VT 2558 is preset at the factory for
TONE dialing.
.
If you have rotary service, press PROG/MEM,
* , #, PROG/MEM to switch to PULSE.
.
To return to touch tone service, press PROG/
MEM, * , * , PROG/MEM.

Temporary Tone

If you have rotary (dial-pulse) telephone service,
(TONE/PULSE setting is set to PULSE), this feature
allows you to enter special codes and tones to
operate answering machines, use electronic banking
services, calling cards, or other special services.
• Dial the call normally.
• Activate the Temporary Tone feature by pressing
TONE (the * key).
• You can then press the numbers or symbols you
need, and your phone will send the proper signals.
• To end the call, press OFF or place the Handset
back in the Base. The phone will automatically go
back to rotary (dial-pulse) service.

Programming the Ringer Type

The Handset ringer is capable of four different types
of ringing tones. To select a different ringer type do
the following:
• Press PROG/MEM.
• Press the # key.
• Press a key 1 - 4 to select a ringer type.
• Press the PROG/MEM key to confirm.
NOTE: To program, the Handset must be OFF.

Turning Off the Ringer

To turn off the ringer on the Handset, do the following:
• Press PROG/MEM.
• Press the # key.
• Press 5 to turn off the ringer. Press the PROG/
MEM key to confirm.
• To turn the ringer on again, see Programming
the Ringer Type.
10