Table of Contents
Advertisement
8. SIMULATING THE HARDWARE STATUS
● Target
Shows the name of each simulated hardware device.
Fan condition
Temperature condition inside the
chassis
Drive condition
Memory condition
General purpose external contact
input condition
General purpose external contact
output condition
● Status
Shows the currently set status of each simulated hardware device. The following
shows a list of statuses for each hardware device.
Category
Fan condition
Temperature condition
inside the chassis
Drive condition
Memory condition
General purpose external
contact input condition
General purpose external
contact outputcondition
(*) This status only applies to drive bay 1 and drive bay 2 in the B and T models.
After the Simulation Tool window starts, all hardware devices are set to "Normal"
or "Healthy".
● Setting
Shows a new status to be simulated for each target hardware device.
If no status to be simulated is set, "---" is displayed. (After the Simulation Tool
window starts, "---" is displayed for all hardware devices.)
Category
Target
PS fan, Front fan1, Front fan2
Internal Temperature
Drive bay1, Drive bay2, Drive bay3 Healthy, SMART Detected,
DIMM A1, DIMM A2, DIMM B1,
DIMM B2
GENDI, GENDI0, GENDI1, GENDI2
GENDO0, GENDO1, GENDO2
8-8
Target
PS fan, Front fan1, Front fan2
Internal Temperature
Drive bay1, Drive bay2, Drive bay3
DIMM A1, DIMM A2, DIMM B1,
DIMM B2
GENDI, GENDI0, GENDI1, GENDI2
GENDO0, GENDO1, GENDO2
Normal, Error
Normal, Error
Overrun, Not Connected,
Offline (*), Rebuild (*)
Normal, Error, Failure,
Not Mounted
Open, Close
Open, Close
Status
Advertisement
Table of Contents
