Selecting The Media Device And Source; Adjusting The Volume And Audio Levels; Adjusting The Volume; Adjusting The Audio Level - Garmin GPSMAP 9 3 Series Owner's Manual

Selecting the Media Device and Source

You can select the media source connected to the stereo. When you have multiple stereo or media devices
connected on a network, you can select the device from which you want to play music.
NOTE: You can play media only from sources that are connected to the stereo.
NOTE: Not all features are available on all media devices and sources.
1 From the media screen, select Devices, and select the stereo.
2 From the media screen, select Source, and select the media source.
NOTE: The Devices button only appears when more than one media device is connected to the network.
NOTE: The Source button only appears for devices that support multiple media sources.

Adjusting the Volume and Audio Levels

Adjusting the Volume

NOTE: If your vessel's media system is set up in zones, the volume controls on the media screen adjust the
volume for the Home Zone
From the media screen, use the slider or

Adjusting the Audio Level

You can use the equalizer to adjust the audio levels on a connected media device.
NOTE: If the media system has multiple zones, adjusting the audio level tone controls affects the home zone
only. You can change the home zone to adjust the audio levels in other zones
page 153).
1 From the media screen, select Options > Audio Levels.
2 Select or to adjust the audio levels you want to change.

Muting the Media Volume

1 From the media screen, select
2 If necessary, select Select.

Automatic Volume Adjustment Based on Speed

If your stereo is connected to a NMEA 2000 network with a device that provides speed information such as an
engine, chartplotter, GPS antenna, water speed sensor, or wind speed sensor, you can set the stereo to adjust
the volume automatically based on the selected speed source
on Speed, page 152).
For example, if a chartplotter with an internal GPS antenna or a stand-alone GPS antenna is on the same NMEA
2000 network as the stereo and you set the Speed Source to Speed Over Ground, the volume increases as your
speed increases.
NOTE: When the volume increases to adjust for speed, the actual volume output changes, but the volume-level
indicator bar and number stays the same.
For more information about connecting the stereo to a NMEA 2000 network, see the installation instructions for
your stereo.

Enabling Automatic Volume Adjustment Based on Speed

1 From the Media screen, select Options > Installation.
2 Select the name of the stereo.
3 Select Zones > Speed Vs Volume > Enable.
4 If needed, update the settings to select the speed source and volume settings.
For more information on configuring the volume settings based on speed, see the latest Owner' Manual for
the stereo.
152
(Selecting the Home Zone,
and
.
page 153).
to adjust the volume.
(Selecting the Home Zone,
(Enabling Automatic Volume Adjustment Based
Media Player