Table of Contents
Advertisement
Do not overtighten the nut. Overtightening the nut can break the terminal bolt, and a broken terminal bolt
cannot be used or repaired.
8 Lower the protector to cover the positive terminal.
9 Repeat steps 3 through 8 for the negative terminal and the 6 AWG ground wire (not included).
Configuring the Device
Some digital switches must be configured through a Garmin chartplotter before use. You must connect all
switches and switched devices to the Garmin Boat Switch device and power before configuring them using a
Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device.
Accessing Digital Switching
Digital switching is controlled through a Garmin chartplotter connected to the same NMEA 2000 network as the
Garmin Boat Switch device.
NOTE: Some switches only appear when the Garmin Boat Switch device is in calibration mode
Tank Sensors, page
19). You may need to add a page to see new switches after adding a device to the wiring
harness or entering calibration mode
From a Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device,
select Vessel > Switching.
Adding a Switch Page
You may need to add a page to see new switches after adding a device to the wiring harness or entering
calibration mode.
From a Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device,
select Vessel > Switching > Options > Setup > Add Page.
NOTICE
(Adding a Switch Page, page
17).
(Calibrating the
17
Advertisement
Table of Contents
