Advertisement
Package Contents & System Diagram
• 3.5˝ LCD Monitor w/Mirror Mode Display
• Color CCD Bullet-Type Camera w/Cable
• Angled Controller Rings (3 sizes)
• Fixing Rings
• A/V Control Module
LCD
• Monitor Cable
Monitor
CCD
Camera
Camera Installation
Fig. 1
1. Locate a suitable camera mounting location on the Car Body
(i.e. center of the rear bumper). (Fig. 1)
2. Drill a 1-
1
⁄
˝ diameter hole at that location.
8
3. Attach the desired Angled Controller Ring to the Camera
Body before installing.
4. Insert the Camera Body through the car body and attach the match-
ing Angle Controller Ring and spacer to the Camera Body.
5. Secure the Fixing Rings to the threaded portion of the Camera Body
locking the camera in place.
+12V
Battery
A/V Control
Ground
Module
+12V
Reverse light
6. Remove the panel located above the bumper inside the back of
the vehicle.
7. Drill a
1
⁄
" hole under the center of
2
the panel for routing the wire in
the vehicle. (Fig. 2)
8. Route the cable to the location
(i.e. under the seat or in the panel).
A/V Control Module Installation
1. Locate suitable A/V Control Module mounting location
(i.e. center console).
2. Attach the A/V Control Module wires as follows:
Wire Color
1. Red
2. Orange
3. Black
3. Secure the A/V Control Module using the provided screws.
Fig. 2
Connection
+12V Battery
+12V Reverse Light
Ground
Advertisement
