Ource Name - Hitachi CP-A200J User Manual

SCREEN menu
SCREEN menu (continued)
Item
MESSAGE
SOURCE NAME
(continued on next page)
42
Using the ▲/▼ buttons turns on/off the message function.
TURN ON TURN OFF
When the TURN ON is selected, the following message function works.
"AUTO IN PROGRESS" while automatically adjusting
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
"Searching..." while searching for the input
"Detecting..." while an input signal is detected
The indication of the input signal displayed by changing
The indication of the aspect ratio displayed by changing
The indication of the PICTURE MODE displayed by changing
The indication of the MY MEMORY displayed by changing
The indication of the TEMPLATE displayed by changing
The indication of "+++ FOCUS +++" displayed by changing
The D-ZOOM dialog displayed by changing
The indication of "FREEZE" and "II" while the projector is in the FREEZE mode.
• If the projector goes into the FREEZE mode while the TURN OFF
is selected, the picture on screen is frozen without any messages,
which is not a malfunction (
Each input port for this projector can have a name applied to it.
(1) Use the ▲/▼ buttons on the SCREEN menu to
select SOURCE NAME and press the ► button.
The SOURCE NAME menu will be displayed.
(2) Use the ▲/▼ buttons on the SOURCE
NAME menu to select the port to be named
and press the ► button. Right side of the
menu is blank until a name is specified.
The SOURCE NAME dialog will be displayed.
(3) The current name will be displayed on the
first line. Use the ▲/▼/◄/► buttons and the
ENTER or INPUT button to select and enter characters. The RESET
button can be used to erase 1 character at a time. Also if you move the
cursor to DELETE or ALL CLEAR on screen and push the ENTER or
INPUT button, 1 character or all characters will be erased. The name can
be a maximum of 16 characters.
(4) To change an already inserted character, press the (▲) button to
move the cursor to the first line, and use the ◄/► buttons to move the
cursor on the character to be changed.
After pressing the ENTER or INPUT button, the character is selected.
Then, follow the same procedure as described at the item (3) above.
(5) To finish entering text, move the cursor to the SAVE on screen
and press the ENTER or INPUT button. To revert to the previous
name without saving changes, move the cursor to the CANCEL on
screen and press the ENTER or INPUT button.
Description
23).