Westinghouse iGen4000DFcv User Manual page 25

Hide thumbs Also See for iGen4000DFcv:
Table of Contents

Advertisement

Available languages

Available languages

MAINTENANCE
CLEANING THE SPARK ARRESTOR
See Figure 21.
Check and clean the spark arrestor according to the figures
specified in the Maintenance Schedule or the engine
manual (if applicable). Failure to clean the spark arrestor
will result in degraded engine performance.
l Turn the generator off and allow the engine to cool for
30 minutes.
l Place the generator on a level surface in a well-ventilated
area.
l Remove the two screws securing the spark arrestor
bracket.
l Remove the bracket, screen, and spark arrestor from the
generator.
l Gently clean the screen and spark arrestor using a wire
brush.
l Reinstall the spark arrestor, screen, and bracket. Tighten
screws securely.
DRAINING THE FUEL TANK AND
CARBURETOR FLOAT BOWL
See Figures 22 - 24.
WARNING
tainer approved for gasoline. Unapproved containers
can break or deteriorate allowing gasoline or gasoline
vapors to escape which can create a serious hazard.
Even properly stabilized fuel can leave residue and cause
corrosion if left long term. If storing the generator for two
to six months, drain the float bowl to prevent gum and var-
nish buildup in the carburetor. If storing the generator for
longer than six months, drain the fuel tank to prevent fuel
separation, deterioration, and deposits in the fuel system.
l Turn off the generator and allow the engine to cool for
30 minutes.
l Place the generator on a level surface in a well-ventilated
area.
Todrainthefloatbowl:
l Turn the fuel selection switch to the PROPANE position.
l Remove the engine service cover.
l Locate the drain valve on the bottom of the carburetor
float bowl.
l Attach a drain hose onto the drain valve.
l Place the bottom end of the hose outside the generator
into an approved gasoline container to catch the drained
fuel.
l Rotate the drain valve counterclockwise to open.
l Close the drain valve by rotating clockwise when the float
bowl is empty. Install the engine service cover.
Torunthefloatbowldry:
l Start the generator as described earlier.
l After the engine starts, turn the fuel selection switch to
the PROPANE position.
ALWAYS store gasoline in a con-
FIG. 21
A - Spark Arrestor
B - Screen
C - Screws
D - Bracket
FIG. 22
A
A - Drain valve
B - Drain hose
A
C
D
English | 25
B
B

Advertisement

Table of Contents
loading

Table of Contents