Controls And Indicators.10 - Kenwood KA-892 Instruction Manual

Controls and indicators
SPEAKERS A and B switches
A,B OFF: This position silences all speakers to permit private use of
headphones.
A ON: Activates speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON: Activates the speakers connected to the SPEAKERS B
terminals on the rear panel.
A,B ON: Activates the speakers connected to the SPEAKERS A
and B terminals simultaneously.
SPEAKERS
A B
ONn a OFF
b
• When speakers are connected only to the SPEAKERS A terminals,
the sound will not be heard if both the SPEAKERS Aand B switches
are depressed to the ON position.
STAND BY mode of POWER key
When the power cord of this system is plugged into an AC outlet, the
STAND BY indicator lights up regardless of the ON/OFF setting of the
POWER switch. This indicates that a small amount of current is being
supplied to the unit to back up the memory contents. This mode is
referred to as the Stand By mode. While the STAND BY indicator is lit,
the power of the system can be switched ON/OFF from the remote
control unit.
10
KA-892 (En)
For the system control of KENWOOD system components, connect them using the system control cords as shown in the
illustration below.
If the power cords are connected as shown in the illustration, the power of the whole system can be switched ON/OFFfrom