Table of Contents
Advertisement
■ Programming operation
Remote control signals of other remote control units can be programmed under space keys on this unit. For space keys,
refer to "Modes" on the previous page.
r
I
Set the LEARN/USE switch to the LEARN
oosition.
_- ._
2 Set to the desired mode.
CDO
Position the remote control units so that their
transmitters face each other.
The distance between the remote control units is about 2 to 5
© Press one of the keys to be programmed.
•
The LEARN indicator lights up.
© Hold down the key of the other remote control unit
containing the signal to be programmed.
•
Programming is complete when the lighted LEARN indicator
goes out after blinking twice.
•
Hold the key of the other remote control unit depressed until the
LEARN indicator goes out.
•
To program another remote control signal, repeat steps 2 to 4
again.
\i&U\\
)
Press while the LEARN
indicator is lighted.
Notes:
1. If the optical output level of the other remote control unit is higher,
programming may not be carried out correctly.
If this occurs,
separate this unit and the other remote control unit by a greater
distance and perform the programming procedure again.
2. If the LEARN and TRANSMIT indicators blink simultaneously
during programming, this indicates either that the key being
programmed cannot be programmed or that programming has not
been performed completely.
If this occurs, perform the
programming procedure again.
3. Remote control functions using signals other than infrared signals
or specially-coded signals cannot be programmed. Programming
is also impossible when this unit's memory capacity becomes full.
4. The LEARN indicator goes out 30 seconds after a programmable
keyispressed. Afterthis, programming is impossible. Tocontinue
programming, press the programming key again.
5. When two or more programmable keys are pressed at the same
time, the key which was pressed last will be programmed.
6. Do not program the remote control functions of equipment other
than A/V components, such as air conditioners, etc.
22
KA-892 (En)
Advertisement
Table of Contents
