Panasonic NV-DS99EN Operating Instructions Manual page 83

OTHER FUNC I IQN S
REC SPEED
►SP
AUDIO REC ^1 2bit
•WIND CUT
►OFF
SCENE I NDEX^2HOUR
REMOTE
►V C R1
REC LAMP
►OFF
BEEP SOUND^OFF
DEMO MODE
►OFF
RETURN
L P
1 Bbit
ON
DAY
VCR 2 OFF
ON
ON
ON
YES
[CAMERA FUNCTIONS] (*Kfgff2tftIft8&)
(»±H)
ENGLISH
Camera Mode Main-Menu [CAMERA FUNCTIONS]
(Continued)
[OTHER FUNCTONS] ^$1$ <§)
© ^SS/WI^[RECSPEED](-M5)
© [AUDIO REC] (-► 64)
© [WIND CUT]
[WIND CUT] g£g£[ON]Hf .
© ««*?IHXfi[SCENElNDEX](->36)
© [REMOTE] (-► 71)
© f*lfc«[RECLAMP](-M8)
© WHS* [BEEP SOUND]
[BEEP SOUND] g£S£[ON] B# * £T5!lt?S>ftT ' M
ismhm
•
mmmmm
• ^M[POWER] () KIH!8fe[0FF] (S8) [OMREA]
(IW)I
2»»B»§
• ££!?£$$$
io»»nira
© STOIIflfll [DEMO MODE]
■ JI#[POWER](B350MBI
HkSaiCAMERA](»»»«!) -
^mw.m • mg&wmmm
°
' tt«j»[DEMOMODE]M£[ON] - -
' WJSA—AIH&B • ^[DEMO MODELS
§ft[OFF] «
© £l°]iS8i?tiftjttflg±gB [RETURN]OS®)
[OTHER FUNCTIONS] Sub-Menu ©
© Recording Speed Mode [REC SPEED] (•+ IS)
© Audio Recording Mode [AUDIO REC] (-» 64)
© Wind Noise Reduction [WIND CUT]
If you set [WIND CUT] to [ON], the noise of the wind hitting
tte microphone is reduced. However, this also causes a
slight deterioration of the sound reproduction in the bass
range.
© Scene Index Mode [SCENEINDEX] (-> 36)
© Remote Controller Mode [REMOTE]
(-> 71)
© Recording Lamp [REC LAMP] (-» 18)
© Beep Sound [BEEP SOUND]
If you set [BEEP SOUND] to [ON], a confirmation/alarm
beep sound is emitted in the following cases:
1 Beep
•When you start recording
•When you switch the [POWER] Switch from [OFF] to
[CAMERA]
2 Beeps
•When you pause recording
10 Beeps
•When you operate the Movie Camera in an
inappropriate way before or during recording
© Demonstration Mode [DEMO MODE]
If you connect the AC Adaptor to the Movie Camera, set
the [POWER] Switch to [CAMERA] without any cassette
inserted, and leave it on for approximately 10 minutes
without performing any operation, the Movie Camera
automatically switches over to the Demonstration Mode to
show its functions.
Pressing a button or performing some other operation
suspends the Demonstration Mode. Leaving the Movie
Camera again on for more than 3 minutes without
operating it, causes the demonstration to start again.
Also, when you set [DEMO MODE] to [ON] and then exit
the menu, the demonstration starts.
To cancel the Demonstration Mode, insert a cassette or set
[DEMO MODE] to [OFF],
© Returning to the Camera Mode Main-Menu [RETURN]