ENGLISH
The 3 Types of Power Supplies
*»»*?*«* ■ ffisai#s£#tijfias >
m
mm±m -
2 sp±bwst • nm^iuismAWKnBBwa
AIMS&KW&MteB •
8S&!ISR|q]T»® •
MM
nm-mmmmisi
•
3 Wa3iEllAM«»S-miCSSS3iEII«8 -
4 «3;7K£«i»sai£££ai»»8 •
5 »3t*i«a«is-aas$53iEiaffi •
PH9H«SE£[0FF] •
•
mm ■
irn
■ Supplying Power from an AC Mains Socket
1
Hook your finger on the protruding edge O of
the Finder, slide the Finder backward to Its fully
extended position and then tilt It upward.
Do not pull on the Eyecup to extend the Finder.
2
Insert the battery-shaped connector of the DC
Input Lead as shown above into the Battery
Holder on the Movie Camera and slide it
downward until it locks with a click.
3
Connect the other end of the DC Input Lead to
the AC Adaptor.
4
Connect the AC Mains Lead to the AC Adaptor.
5
Connect the other end of the AC Mains Lead to
an AC mains socket.
® Hong Kong Special Administrative Region of China
• Before disconnecting the AC Mains Lead, set the
[POWER] Switch on the Movie Camera to [OFF],
•If you use the Movie Camera for a long time, it becomes
warm. However, this is normal.
•
mm
□°q) -
■ Supplying Power from the Cigarette Lighter
Socket in a Car
The use of the Car Adaptor Cord (VW-KA7E; optional)
together with the AC Adaptor makes it possible to supply
power to the Movie Camera in a car for recording and
playback. It also allows charging the Movie Camera's Battery.
•After use, be sure to disconnect the Car Adaptor Cord from
the Cigarette Lighter Socket.
• Be sure to start the car engine before you connect the Car
Adaptor Cord, otherwise the fuse may blow.
•Use the DC Input Lead supplied with the AC Adaptor.
•Quick-charging is not possible when the Car Adaptor Cord is
connected to the AC Adaptor.
•Also read the operating instructions of the Car Adaptor Cord.