Table of Contents
Advertisement
OPERATING THE TUNER
Press the POWER
switch to the ON position.
Select TUNER with the input selector.
Be sure to turn the TAPE
2 MONITOR
button OFF when
listening to AM or FM broadcasts.
Switch ON the SPEAKERS
button corresponding to the
speakers you wish to use.
FM auto stereo reception and monaural reception
Each time you press the MPX MODE
button, the MONO
indicator in the display section lights or goes out.
e@ |f an FM stereo broadcast is received when the MONO
indicator is out, the STEREO indicator lights, and sound is
in stereo.
@
lf an FM stereo broadcast is received when the MONO
indicator is lit, the sound will be monaural.
If there is
interference during stereo mode reception, switch to
mono. The sound will become monaural but interference
will be reduced.
TUNING INTO STATIONS
Turn the MULTI-JOG, and the tuning frequency changes.
Turning in a clockwise direction raises the frequency, while
turning in a counter-clockwise direction lowers the frequency.
1
2
3
1. Use the FM/AM button to select either FM or AM.
Confirm that the JOG MODE indicator in the display shows
"FREQ".
If "ST" is displayed, press the SELECT button to switch to
"FREQ".
2. Turn the MULTI-JOG until you reach the frequency of
a desired station.
When a station is received, the TUNED indicator will light up.
NOTE:
The TUNED indicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremely weak.
3. Adjust the volume and tone as desired.
Auto tuning
Auto tuning is convenient when you do not remember the
frequency of a desired station, or when you wish to find
stations that you do not normally listen to. Operate by remote
control. (Refer to page 22.)
PRESET TUNING
FREQUENCY PRESETTING
1. Tune into the desired station.
See the section "TUNING INTO STATIONS". In addition
to station frequencies, the MPX MODE (auto stereo mode
or monaural mode) can also be preset (FM only).
16
<ARB7061>
2. Press the MEMORY
button.
The station number flashes in the display. (Memory mode)
3. Turn the MULTI-JOG to select the station you want
to memorize, and press the ENTER button.
® The station number lights in the display, indicating that
it has been memorized.
e |f you do not press the ENTER button within about
five seconds after selecting a station, the memory
mode is canceled.
4. Repeat steps 1 to 3 to preset additional stations.
A total of 30 AM and FM stations may be preset. When
you store a new preset, it takes the place of the previously
stored station (if any).
Advertisement
Table of Contents
