Plejd DAL-01 Installation Manual

Advertisement

Quick Links

Mains electricity

230 VAC/50 Hz, max 0.05 A

Standby power

0.4 W

External operating temperature

-25 to +35 °C

Dimensions

46x46x18 mm

Protection

Overtemperature software

Short circuit protection

DALI bus

Max 64 DALI loads
Guaranteed supply current 128 mA
Maximum supply current 150 mA
Max cable length 300 m (1.5 mm
)
2

Basic insulation

Radio

2.4 GHz mesh
Bluetooth®
<10 dBm
Radio range
Approx. 10 m indoors
The Plejd mesh technology extends the range by
allowing the units to communicate with each other
RISK OF INJURY TO PERSON OR PROPERTY
All work on the appliance must be carried out by
an authorized electrician. National laws and
regulations must be followed.
Compliant to standards
Hereby, Plejd AB declares that the radio
equipment type DAL-01 is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: plejd.com/compliance
Plejd AB, Krokslätts Fabriker 27A
431 37 Mölndal, Sweden
Important information
Do not use the product if it has visible signs
of damage.
Disposal and recycling
This electrical product should not be disposed
of together with other household waste. Contact
your local recycling center for guidance on
electrical and electronic equipment disposal.
EN
D A L- 0 1
INSTALLATION MANUAL
Further information can be found
in the Plejd app or at plejd.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DAL-01 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Plejd DAL-01

  • Page 1 Radio range of together with other household waste. Contact Approx. 10 m indoors your local recycling center for guidance on The Plejd mesh technology extends the range by electrical and electronic equipment disposal. allowing the units to communicate with each other...
  • Page 2 ® Connect the product according to the wiring diagram. internet connection. DAL-01 comes with a built-in power supply, so there is no need to use a dedicated DALI power supply for the DALI bus. Hand over the Plejd system The short circuit protection activates after 2 seconds, and recovers after 13 seconds.

Table of Contents