Kenmore 79030522802 Installation Instructions Manual page 3

GAS WALL OVEN INSTALLATION INSTRUCTIONS
2. Connect Electricity to Gas Wall Oven
For personal safety, these appliances must be
properly grounded.
CIVAGOTING) This appliance is equipped with a
three-prong grounding plug for your protection
against shock hazard and must be plugged directly
into a properly grounded receptacle. Do not cut or
remove grounding prong from this plug.
The wall receptacle and circuit should be checked
by a qualified electrician to make sure the
receptacle is properly grounded.
Where a standard 2-prong wall receptacle is
installed, it is the personal responsibility and
obligation of the consumer to have it replaced by a
properly grounded 3-prong wall receptacle.
Preferred Method
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
ow
ie
Power supply cord with
\ 3-prong grounding plug
Grounding
type wall
receptacle
Figure 2
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
If an external electrical source is used, the
appliance, when installed, must be electrically
grounded in accordance with local codes or in their
absence of local codes with the National Electric
Code ANSI/NFPA No. 70-1987 or latest edition.
Check all code rules and regulations for connecting
the wall oven to be certain the installation
conforms with all local, municipal and state codes
as well as local utility regulations.
Failure to comply with the above could result in a
serious shock hazard.
Note: All hook-ups and adjustments shall be
performed by qualified technicians.
Ne Disconnect electrical supply cord
from wall receptacle before servicing wall oven.
3. Alternate construction
(Model with 1/2 oven cavity only)
Installation Instructions for installing a 1/2 cavity
oven into an existing 2 cavities opening with
dimensions 42-1/8" height by 22 2" Width.
»
42 1/8")
i od
Plywood
filler
¥
Wood [s.
runner [CS ]
eight
adjuster
Figure 3
° If width opening is too wide to secure unit to
cabinet with mounting screws, add plywood filler
strips.
° If height opening is at 42-1/8", lower height
adjuster 1" (see section 4) and secure two 2" X
4" X 22" wood runners on each side at bottom of
opening (see figure 3).
* The decorative lower trim (not shown} can be
installed to hide the gap under the unit. It should
overlap by 14" the front of the cabinet at bottom
of cutout (see step 2 of section 5).