Transportation And Lifting - Airwell VVFA Series Service Manual

Arrival inspection
• After receiving the machine, should check whether there is transport damage. If any damage is found on the
surface or inside, it shall be reported immediately to the shipping company in writing.
• Check the product model, electrical parameters (power supply, voltage, frequency) and accessories to determine
whether they meet the requirements.

9.3 Transportation and lifting

Lifting
In front of the unit shipped from unpacking location as
close as possible.
• Do not place anything on the device.
• Two ropes shall be used for lifting the outdoor unit.
Hoisting method
Hoisting to ensure that the level of outdoor machine,
slowly lifting.
1. Removal of outer packing is strictly prohibited
2. As shown by two ropes hoist with outdoor machine
packaging.
• In order to ensure safety, maintain the level of lifting,
slowly lifting.
• Do not lift the elevator to the packing and outer
packing of the equipment.
• External protection should be used when lifting, such
as cloth or cardboard.
Manual handing
• In the installation and commissioning, the outdoor machine do not put any irrelevant material, to ensure that
there is no debris inside the machine, or there may be a fire or accident.
Pay attention to the following points when handling the equipment manually:
1. No demolition wood base.
2. In order to prevent the dumping of the outdoor machine, the center of gravity of the unit should be noted as
shown in the figure.
3. Two or more people to carry out the outdoor machine.
Wood base
CAUTION
CAUTION
Handle hole
rope
CAUTION
This product maximum tilt
angle 20 degrees.
Focus
18
Over 60 degrees
0.7~1.0 meters
Do not remove
packing tape and
packing box.
As shown in the
rope through
the wood base
around the lifting
hole.