Advertisement
16. Tap a 1" x 1 1/2" Inner Cap (23) into a Handle
(26). Tap a 1" Round Cap (22) into the Handle.
Apply lubricant to a 3/8" x 2 1/2" Bolt (3). Attach
the Handle (26) to the Press Arm (28) with the
Bolt and a 3/8" Jam Nut (2).
Remove the adhesive backing on a Square
Bumper (9). Apply the Bumper to the Handle (26)
in the indicated location.
Assemble the other Handle (26) to the Press Arm
(28) in the same manner.
17. Find the end of the Short Cable (44) where the
rubber stop is located. Lay the end of the Cable
over a 3 1/2" Pulley (12). Attach the Pulley to the
Frame (80) with a 3/8" x 3 3/4" Bolt (83), a 3/8"
Flat Washer (4), and a 3/8" Jam Nut (2). Note:
Be sure that the Short Cable is between the
Pulley and the lat bar bracket.
18. Lay the Short Cable (44) over a 3 1/2" Pulley
(i ON
Di iIIaw or»rl
Pi illow P.nworc (1
y I
*-f- •
I II IV I
UiiWJf
vii iu
w
I
J
w*-~ •". w
v
'
~
}
to the Frame (80) with the 3/8" x 4 1/2" Bolt (90)
and a 3/8" Jam Nut (2). Make sure that the
Pulley Covers are turned so the wide tabs are
positioned as shown.
Tighten the 3/8" Jam Nut (2) used in assembly
step 7.
19. Assemble the two 4 1/2" Pulley Covers (87), the
two "I" Plates (86), and the two 4 1/2" Pulleys (85)
with the two 3/8" x 1 3/4" Bolts (14) and two 3/8"
Jam Nuts (2).
10
Advertisement
