Using The Pedal - Jet Eternity Delay Manual

Operating your Eternity Delay

Using the Pedal

Power the Eternity with a 9v DC negative tip power supply, one that is capable of handling up to
300mA of current. Upon powering the Eternity the Mix and Repeats knobs will glow indicating
startup mode. Once the Tap LED begins to flash the Eternity is ready to use. Tap the Bypass switch
to engage the pedal (Live Mode), the color of the Repeats knob indicates the active algorithm and
the color of the Mix LED indicates the cue'd up Preset.
Hold the Bypass switch for 1 second and release to change algorithms.
Light Blue | Tape Delay
Green | Digital Delay
Yellow | Analog Delay
Red | Dual Delay
Pink | ESD Delay (Echo, Slap, Doubler)
White | JRD (JET Signature Rhythm Delay)
To engage Preset Mode, double tap the Bypass switch. This will quickly jump between the delay
used in Live Mode to the delay stored in the cue'd up preset. To disengage Preset Mode and jump
back to Live Mode, double tap the Bypass switch again.
To change presets, tap both the Tap switch and Bypass switch to cycle through the stored presets:
Light Blue | Preset #1
Green | Preset #2
Yellow | Preset #3
Red | Preset #4
Pink | Preset #5
White | Preset #6
While in Preset Mode you can rotate the knobs to see the saved location of each knob in the stored