Table of Contents
Advertisement
7.10 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking odours and roasting
odours. Depending on the setting of the sensor sensit-
ivity, the optimum fan setting is automatically switched
on.
If the sensor control reacts too weakly or too strongly,
you can change the setting for the sensor sensitivity.
¡ Default setting: Fan setting 3
¡ Lowest setting: Fan setting 1
¡ Highest setting: Fan setting 5
7.11 Setting the sensor sensitivity
Requirement: The appliance is switched on.
Press and hold
and
1.
Press
or
to change the setting.
2.
Press
to save the setting.
3.
Or wait approx. five seconds until the setting is
saved automatically.
a A signal tone sounds as soon as the selected set-
ting is saved.
7.12 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Note: You can set the saturation indicator in the Home
Connect app depending on the filter used.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.13 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched on.
Press and hold
and
1.
To set circulating-air mode (Clean Air Standard
‒
circulating-air set or Clean Air Plus circulating-air
set), press and hold
the LED display.
To set circulating-air mode (regenerable filter),
‒
press
/
until LED 3 lights up in the LED dis-
play.
To convert the electronic control back to opera-
‒
tion without the air recirculation filter, press
until LED 1 lights up on the LED display.
Press
to save the setting.
2.
Or wait approx. five seconds until the setting is
saved automatically.
a A signal tone sounds as soon as the selected set-
ting is saved.
1
Depending on the appliance specifications
1
1
for approx. 3 seconds.
for approx. 3 seconds.
/
until LED 2 lights up in
7.14 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After switching off the appliance, the upper two LEDs
for the grease filter's saturation indicator and/or the
lower two LEDs for the odour filter's saturation indic-
ator flash in the left hand control panel.
¡ A signal sounds repeatedly.
Press
.
▶
a The saturation indicator is reset.
7.15 Switching on Guided Air
With the Guided Air function, the cooking vapour is
routed in such a way that it can be optimally collected
from the appliance and removed. The extraction of the
cooking vapour is improved on front cooking zones in
particular.
Note: This function is switched off by default.
Press .
▶
7.16 Switching off Guided Air
Press .
▶
/
Basic operation en
9
Advertisement
Table of Contents
