Familiarising Yourself With Your Appliance; Before Using For The First Time; Basic Operation - Bosch DWK 5DK Series User Manual And Installation Instructions

en Familiarising yourself with your appliance

Familiarising yourself with your appliance

5 Familiarising yourself with your appliance
5.1 Controls
You can use the control panel to configure all functions of your appliance and to obtain information about the operat-
ing status.
Switching the appliance on or off
⁠ Switches on fan setting 1.
⁠ Switches fan setting 2 on.

Before using for the first time

6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
Note: When using it in circulating-air mode, you require
additional accessories.
Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.

Basic operation

7 Basic operation
7.1 Switching on the appliance
Press ⁠ .
▶
a The appliance is activated for one minute.
7.2 Setting a fan setting
Press ⁠ , ⁠ or ⁠ to adjust the fan setting.
▶
7.3 Switching off the appliance
Press twice.
▶
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Press ⁠ .
▶
a The appliance automatically switches off after ap-
prox. 6 minutes in the previous state.
20
⁠ Switches on fan setting 3.
Intensive mode
Switch the lighting on or off.
Note: The saturation indicator for the grease filter is set
as standard. For use in the circulating-air mode, you
must also activate the saturation indicator for the odour
filter.
Requirement: The appliance is switched off.
Press and hold and
▶
lights up briefly first and then and
a
up at the same time.
a The saturation indicator for the odour filters is activ-
ated.
7.5 Switching off intensive mode
Press or set another fan setting.
▶
a Intensive mode is ended early.
7.6 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press ⁠ .
▶
7.7 Switching off the lighting
Press ⁠ .
▶
7.8 Saturation indicator
The saturation indicator informs you about when the
grease filter has to be cleaned and when you have to
change the odour filter.
¡ If the grease filter has to be cleaned, flashes.
¡ If the odour filter needs to be replaced,
for 3 seconds.
briefly light
flashes.