Advertisement
Chapter 3 Installation and commission
Carefully read the manual before installation and the change on the parts of the
machine without the permission of the manufacturer can cause the damage to the
machine;
Installation and commission person must have some knowledge relating to
electrical;
Operator must under the special training and pass the examination;
You must carefully check the equipment list and contact the dealers or our
company if you are in doubt;
To ensure the installation and commission complete successfully, please
prepare the following common tools:2pcs open spanners (10"), I pc socket key,
1pc hexangular spanner, 1pc pliers, 1pc screw, 1pc hammer and 1pc universal
electric meter
3.1 Open the box
3.1.1 In accordance with the instruction on the package box, open the package box and
remove the package material and check if the machine is sounded and the accessories if
completed.
3.1.2 Keep the package material far away from the working site and treat it well.
3.2 Install the parts detached
3.2.1 Installation of the air tank
Remvoe the side panel and use 2 pcs M8x25
bolts to connect the air tank at the rear of the
.
body
Use the flat washer(GB95-87)and elastic
washer(GB93-87) and nut (GB6170-85) to fix
the air tank in main body of machine.
The condition of the machine after installation is as indicated in Fig4.
3.2.2 Install the air regulator
Install the air regulator to the right side of the air tank using 2 pieces of M6x10 screw by
.
- 4 -/ 19
Advertisement
