Advertisement
FIG11.
Connect the column and the tilt cylinder then fix them using nuts (FIG11-3).
3.2.5 Connect the inflation gun or inflation gauge.
3.3 Air test:
:
Column tilt back
Connect the air and press down the lock valve button(FIG3-3)to lock the
horizontal arm. Step down column tilt pedal(FIG3-10)and the column tilt back by 25º .
The tilt speed has been setup before ex-work at about 2seconds.After longtime of use,
the speed will be fast or slow and on this condition, you can use the speed valve at the
heads of the push-out cylinder to adjust. Loose the nut and turn adjust screw clockwise,
the speed will be slow and it will be slow if counterclockwise, tight the nut after adjust.
When the machine out of the factory, the air
source fitting has been adjusted well and if you
need to change, you can readjust.
Before the machine out of the factory, the air
regulator has been adjusted well and can be
re-adjust if need.Adjust the pressure: lift-up the
adjusting
knob
(FIG19-1)
clockwise, the pressure will raise. Otherwise,
decline. Press down the adjusting knob after
adjusting.
Adjust the oil feed: twist the adjusting screw
(FIG19-2) clockwise using the screw driver to
slow the dripping speed and otherwise, quicken
it.
Take out the inflation gun then connect it
the open nut and tighten it. Hang the gun to
the hook after installation.
Install the inflation gauge (FIG13-3): fix it
to the installation hole at the side of column
using two pcs M6 screws(GB70-85). Then
connect theφ 8 hose (FIG13-1) on inflation
gauge to the elbow (FIG13-2) on the machine
body back (FIG13).
and
rotate
it
- 7 -/ 19
Advertisement
