Advertisement
Press down the right side of the tire as hard as you can and step turntable pedal (FIG3-12)
to rotate the turntable clockwise to guide the lip into the tire detach slot completely.
If there is tube, raise up the demount tool and put in the tube and position the core.
Mount the demount tool again. Adjust the
position of the upper lip. Use the assistant
press roller and press to press the side of the
tire to make partial of the lip into the tire
detaching slot (FIG24). Step the turntable
rotation pedal to rotate the tire. At this moment,
continue pressing the lip just mounted on the
rim.
When 10~15cmof the tire not into the rim,
change to the step mode. And observe the condition of the tire to avoid the tear of the tire.
Once you feel there is any tear on the tire, release the pedal at once. Then lift up the
pedal by instep to make the motor rotate reverse. Make the tire restore to the original
condition to mount again.
4.4 Inflation
NOTE: When inflating the tire, please be carefully and series obey the operation process.
Check the air route to see if the air connection is OK. This machine is equipped with an
inflation device for monitoring the inflation of the tire and the inflation pressure.
Loose the tire from the turntable.
Connect the inflation hose with the tire air core.
In the process of inflation, you should repeat stepping the inflation pedal. Confirm the
pressure indicated on the pressure gauge not exceed the scope specified by the
- 10 -/ 19
Advertisement
