Advertisement
can reposition.
Use the crowbar to detach until the lip to the hump of the demount tool (FIG17). Step the
turntable rotation pedal(FIG3-12) to rotate the turntable clockwise until the rim of the wheel fall
off.
If the demount of the tire is jammed, please stop the machine immediately and
then lift up the pedal to let the turntable rotate counterclockwise to remove the
resistance!
Take out the tube and then move up the lower lip to contact with the upper edge of the rim
and detach another lip (FIG18). Step the column tilt pedal (FIG3-9) and the column tilt
backwards and at this moment, you can take off the tire.
4.3Mount tire
Clean up the oil and rust on the rim and lock the rim on the turntable.
Spread the lubrication liquid or soap liquid around the lip. Tilt the tire against the rim and
keep the front end upwards. Press down the column tilt pedal (FIG3-9) to make the
column return to the original position. Move the demount head to firmly contacted rim
(FIG16). Position the left of the lip above the tail of the demount tool and the right under
the hump of the demount tool (FIG18).
Press the lock handle press button(FIG3-3)
to lock horizontal arm and hexangular shaft and
the hexangular shaft will automatically move
upwards. The quadric shaft will automatically
backward a little to make the demount tool
detached from the rim of the rim to avoid the
damage on the rim(FIG16)
NOTE: The angle of the demount tool has been
calibrated according to the standard rim (14"). If
handling the extra-big or extra-small rim, you
.
- 9 -/ 19
Advertisement
