Advertisement
hexangular shaft downward by 16# spanner;If the clearance if too small we can adjust the
nuts on the vertical hexangular shaft upward.
Switch off the air source and detach the protective cover at the upper end of the horizontal
arm.Use 5# spanner to loosen the lock nut (Fig21-C)on the M6 screw at the two
end.Adjust the M6 screw,meanwhile use your hand to push the quadric shaft until it runs
smooth and thenlock the nut.Use the spanner to adjust the screwin the middle and
meanwhile lock the horizontal arm and observe the displacement. When the displacement
is 2mm,lock the nut.
If the square locking plate cannot lock firmly, adjust the taper locking pole.(FIG21-D)
CHAPTER 6 TRANSPORTATION
When transport the machine must apply the original package and place according to the mark
on the package. The machine must be transported by the forklift with the corresponding
tonnage(Fig22)and the stacked layer will not exceed 3layers.
- 13 -/ 19
Advertisement
