Installing the terminal cover
After connecting the cables to the rear panel of the device, install the terminal cover. This prevents the cables from
becoming disconnected and protects the ports/jack from dust.
Attach the terminal cover to the device by using the two included terminal cover screws (2.5 mm × 8 mm).
Installing the table stand
Attaching the included table stand allows you to use the device placed on a surface such as a table.
With the hexagonal wrench, use the included hexagonal screws (M3 × 8 mm) to attach the table stand to the device.
Device (rear panel)
* For illustrative purposes, the cable is not shown.
Table stand
* For illustrative purposes, the cable is not shown.
CS-800 User Guide
19
Terminal cover
Terminal cover screw
(2.5 mm × 8 mm)
Hexagonal screw (M3 × 8 mm)
for table stand
Setup and connections