Woods BW240X Operator's Manual page 41

INSTALL CHAIN OR BELT SHIELDING
 Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped when any-
one comes within 300 feet (92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
MAN0725 (10/3/2008)
ANGER
Figure 37. Chain Shielding Installation - Center Section
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Install chain and rubber shields with hardware as
shown. (Refer to Figure 37 and Figure 38 for Chain
Shielding Installation; Figure 39 and Figure 40 for Belt
Shielding Installation.)
NOTE: Chain Shielding: Center Section: Attach rear
chain plates (4) to the top of center section. Attach cen-
ter chain plate (18) to the bottom of the center section.
Wing: Install four (two per wing) 6-link chain sections
(12) and four (two per wing) 4-link chain sections (13)
to the wing skid shoes. Secure with carriage bolts (14)
and flange lock nuts (15). See Figure 38.
1. Front center chain plate
2. Front right chain plate
3. Front left chain plate
4. Rear chain plates
16. 3/8 NC x 1 Carriage bolt
17. 3/8 NC Flange lock nut
18. Rear chain plate, center
Assembly 41