Table of Contents
Advertisement
Install Wing Wheel Yoke Adjustment Link
CAUTION
Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
1. With a lifting device raise right wing and lock in the
up position using the wing lock-up bar. Leave lifting
device attached for added support.
2. Attach adjustable link (turnbuckle, 22) to right side
of center wheel yoke arm and secure with cap
screw (32) and lock nut (26).
3. Attach opposite end of adjustable link (22) to wing
wheel yoke arm and secure with cap screw (32)
and lock nut (26).
4. Remove lock-up bar and carefully lower wing using
lifting device.
5. Repeat process for left wing.
6. See Cutting Height (Normal Mowing) - Wings,
page 16 to level wings.
26
22. Adjustable link
26. 1 NC Lock nut
32. 1 NC x 4 HHCS GR8
DP6
Figure 34. Right Wing Wheel Yoke
Adjustment Link Installed
MAN0725 (10/3/2008)
32
22
Install Wing Driveline
1. Remove knob on top of clutch shield (3) and raise
shield.
2. Slide clutch of driveline (4) over wing gearbox shaft
and align holes with groove.
3. Secure driveline to shaft using cap screws and lock
nuts supplied with driveline.
4. Slide opposite end of driveline over splitter gearbox
and secure using cap screws and lock nuts
supplied with driveline.
5. Repeat process for left driveline.
3. Clutch shield
Figure 35. Right Driveline Installation
FILL GEARBOXES
1. Remove top and side plugs from gearbox.
2. Fill gearbox with SAE 80W or 90W EP oil until it
runs out of side level hole. Install plug in the side
hole and vented dipstick in the top.
3. Allow oil to drain into the lower bearings and
recheck oil level.
4. Fill all gearboxes.
5. Attach hose to each elbow.
Assembly 39
Advertisement
Table of Contents
