Table of Contents
Advertisement
3. Tighten nuts until there is approximately 1 inches
of
thread
exposed
adjustment will be need once cutter is attached to
tractor drawbar. See Cutting Height Adjustment,
page 15.
Install Height Adjustment Cylinder
Refer to Figure 26.
1. Attach base end of cylinder (3) to the cylinder lugs
on the rear of the deck using clevis pin (18) and
two cotter pins (63).
2. Extend cylinder rod and place transport lock
bracket (5) over cylinder rod clevis.
3. Position cylinder rod and transport lock bracket
between lugs on the wheel yoke tube and align
holes.
4. Secure cylinder rod and transport lock bracket to
the wheel yoke tube using clevis pin (19) and two
cotter pins (63).
5. Install cylinder spacers (6) over cylinder rod as
needed. Spacers are used to set cutting height.
3. Hydraulic cylinder 3-1/2"
5. Transport lock-up
6. Cylinder spacers
7. Ratchet
8. SMV Mounting bracket
9. SMV Socket
10. SMV bracket
11. SMV Emblem
18. Clevis pin, 1" x 4.58"
19. Clevis pin, 1" x 5.08"
22. 1/4 NPT x 1/4 NPT x 156" Hose
23. 1/4 NPT x 1/4 NPT Elbow, restricted
24. 1/2 NPT x 1/4 NPT Reducer bushing
35. 5/16 NC Lock nut
36. 5/16 NC x 1/2Carriage bolt
38. 1/4 NC x 1/2 Round head screw
39. 1/4 NC Hex nut
53. 1/2 NC Lock nut
63. Cotter pin, 1/4" x 1-1/2"
67. 1/2 NC x 1-1/2 Carriage bolt
34 Assembly
past
the
nuts.
Further
Figure 26. Spring Arm and Cylinder Installation
6. Install bushing (24), elbow, (23) and hose (22) to
the base end of cylinder (3).
NOTE: Make sure a breather fitting is installed in
the rod end port of the wheel yoke cylinder.
7. An optional ratchet (7) is available, and replaces
the hydraulic cylinder. Install ratchet jack using the
same procedure and hardware used for the
installation of the hydraulic cylinder.
Install SMV Emblem
Refer to Figure 26.
1. Attach SMV mounting bracket (8) to out side of left
cylinder lug. Secure using two carriage bolts (67)
and flange lock nuts (23).
2. Attach SMV socket (9) to mounting bracket (8)
using two carriage bolts (36) and lock nuts (35).
3. Attach SMV emblem (11) to SMV bracket (10)
using two round head cap screws (38) and hex
nuts (39).
Insert SMV bracket (10) with emblem (11) into
socket (19).
MAN0725 (10/3/2008)
Advertisement
Table of Contents
