Aiwa NSX-S505 Operating Instructions Manual page 17

MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press <4 or > during playback referring to the playback side
indicator (<4 or B) on the display.
For example, when ® is pressed while P is displayed,
playback of the next track starts.
Music sensor function may not be able to detect tracks under
the following conditions:
* Blanks of less than 4 seconds between tracks
¢ Noisy blanks
* Long passages of low-end sound
* Low overall recording levels
CONTINUOUS PLAY
Seay +}
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
7 Insert tapes into deck 1 and deck 2.
2 Press TAPE DECK1/2 to select the deck to be
played back first.
3 Press REV MODE to select =).
4 Press <P to start playback.
Playback continues until I is pressed.
About cassette tapes
* To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Type II tape Tab for side A
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
¢ 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
¢ Take up any slack in the tape with a pencil or similar tool | '
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
ENGLISH 16