http://www.xiaoyu163.com PROTECTION OF EYES FROM LASER BEAM DURING SERVICING 3 7 63 1515 0 This set employs laser. Therefore, be sure to follow carefully the CAUTION instructions below when servicing. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous WARNING! radiation exposure.
http://www.xiaoyu163.com NOTE ON BEFORE STARTING REPAIR 1. Forced discharge of electrolytic capacitor of power supply block 3 7 63 1515 0 When repair is going to be attempted in the set that uses relay circuit in the power supply block, electric potential is kept charged across the electrolytic capacitors (C101, 102) even though AC power cord is removed.
Page 5
http://www.xiaoyu163.com 3 7 63 1515 0 In such a case, check also if the POWER AMPLIFIER circuit or power supply circuit has any abnormalities or not. 2-2. Regarding reset There are cases that the machine does not work correctly because the MICROCOMPUTER is not reset even though the AC power cord is re-inserted, or the software reset (pressing the STOP key + POWER key) is performed.
http://www.xiaoyu163.com TRANSISTOR ILLUSTRATION 3 7 63 1515 0 E C B E C B B C E E C B 2SB1370 CD1585BC 2SC3331 DTC114ES CSA952K KTC3199 CSC4115 KTA1266 KTC3198 S D G 2SJ460 2SK2158 2SA1235 CSD1306 2SK360 2SK2541 2SJ461-T1 KRC102S 2SC2714 KRC104S 2SC3052...
Page 25
http://www.xiaoyu163.com 3 7 63 1515 0 < TUNER SECTION > < FRONT SECTION > 10. µ-CON OSC Adjustment 1. Clock frequency Check Settings : • Test point : TP2 (CLK) Settings : • Test point : TP10 and GND Method : Set to MW 1602kHz and check that the test point is •...
http://www.xiaoyu163.com SPEAKER DISASSEMBLY INSTRUCTIONS 3 7 63 1515 0 Type.1 Type.4 TOOLS Insert a flat-bladed screwdriver into the position indicated by the arrows and remove the panel. Remove the screws of each speaker Plastic head hammer unit and then remove the speaker units. flat head screwdriver Cut chisel How to Remove the PANEL, FR...
Need help?
Do you have a question about the NSX-SZ35 and is the answer not in the manual?
Questions and answers