Table of Contents
Advertisement
6. Remove all harnesses from the left side going
through the harness guides towards the back.
Disconnect both thermistor connectors, both
fan motor connectors and reversing valve
connector form the main board. Then break
zip tie holding the indoor coil thermistor in
place and pull it out of its holder.
Thermistors
Fan Motors
Harness
Guides
Zip Tie
Indoor Coil Thermistor
7. Lift indoor fan assembly straight up.
8. Set indoor fan assembly to the right of the
Zoneline. Notice the compressor is still
connected.
Reversing
Valve
9. Remove fan shroud by removing a 13-mm
nut. The nut can be accessed with the heater
assembly installed, or remove the heater
assembly to gain easier access.
– 36 –
13-mm nut
(Continued next page)
Advertisement
Table of Contents
