Assembling The Appliance - Dometic CADAC SAFARI CHEF 30 User Instructions

2. Assembling the appliance

• WARNING: The legs are spring loaded. Opening and closing of the legs must be done in a controlled manner to avoid personal injury or
damage to your Safari Chef.
• To open the legs, turn the unit upside-down and hold the legs down while li ing each leg individually (Fig. 2c). You will hear a "click" if the leg(s)
has located correctly (Fig. 2a).
• To fold the legs back, securely hold the leg and push the leg release clip down (Fig. 4b). Then push the legs in-ward to its closed position (Fig.
2c). This needs to be done sequentially to optimize space. First the right front leg (1), then the le front leg (2), and lastly the rear leg (3) (as seen
in Fig. 2d).
• Before connecting the gas supply, firstly check that the appliance valve is in the off position by turning the control knob fully clockwise (See Fig.
4).
3. Connecting the gas supply and operating the Appliance
Connecting the gas supply
• Before connecting the appliance to a gas supply, ensure that the rubber seal on the regulator is in
position and in good condition.
• Before connecting the hose and regulator to the appliance, check that the appliance control knob
is in the "OFF" position.
• Carry out this check each time you fit the appliance to a gas cylinder.
• Blow out any dust from the gas supply opening to prevent possible blockage of the jet.
• Fit an approved hose and regulator to the appliance.
• Ensure that the gas supply (gas cylinder/gas cartridge) is fitted in a well-ventilated location away
from any source of ignition, such as naked flames and away from other people.
• Do not twist or pinch the hose. Ensure that it is routed away from the stove body so as to prevent
deterioration / damage to the hose caused by heat.
• Make sure that the gas cylinder is kept upright at all times, connect to the cylinder by screwing on
hand tight until fully engaged.
• Ensure that a complete gas seal has been made (check for the smell of gas around the connection
joint). Do not check for leaks with a naked flame. Use warm soapy water only, applied to the joints
and connections of the appliance. Any leakage will show up as bubbles around the leakage area.
• If you cannot rectify the gas leak do not use the appliance. If you are in doubt, contact your nearest stockist.
More information https://www.caravansplus.com.au
Release
clip
Fig. 2a
Fig. 2c
3 3
EN
Fig. 2b
Fig. 2d
Fig. 3