Safety Information - Innova DS200 User Manual

SAFETY INFORMATION

WARNING: Denotes a potentially hazardous situation that may result in injury or death
CAUTION: Denotes a potentially hazardous situation that may result in damage to the meter
NOTE: Denotes a situation that may result in degraded or incorrect measurement
§
Use caution in the operation of this device. Improper use may
result in injury or death. Read this user manual before operating
the meter.
§
Always remove leads before opening the case.
§
Do not operate the meter unless it is fully assembled with both
case screws tight.
§
Only use appropriately rated fuses.
§
Always check for damage before use. Pay special attention to the
test leads for signs of damaged insulation or exposed
conductors. Immediately replace damaged leads.
§
Only use test leads that are rated to at least CAT III 600V Keep
fingers behind the guards on the leads.
CATIII
TABLE 1 SYMBOLS
Caution: Risk of Electric Shock. Refer to operating instructions.
Important Information: Refer to operating instructions.
This instrument is rated for installation category III per IEC 61010.
Double Insulation
Terminal protected by fuse. Current limit of 10A RMS.
Conforms to European Union Directives
Do not exceed 600V with respect to ground.
§
Use caution working with voltages above 30VAC rms, 42VAC peak,
or 60VDC. Voltages this high pose risk of shock.
§
Never apply more than 600V between any terminal and earth
§
ground.
§
Do not apply more than 2.0V to the auxiliary terminal with respect
to Common. Doing so may draw unexpected currents and trigger
protection circuits. In this event, basic functionality will automatically
return within one minute. Accuracy may be adversely affected for
up to five minutes.
§
Error messages may appear on the user interface. Read these
messages for further information
Safety Information
3