Sears PRO-FORM 725 User Manual page 13

TIME/PACE display--
7_E i p_.E
This display shows the I ! 17 " --I. I-'11
elapsed time and your t I L_i- ._/_-i J O
P_
current pace (pace is
measured in minutes per .............
mile). The display will
change from one number to the other every, seven
seconds. The PACE indicator will light when your
current pace is shown. Note: When a preset program
or a custom program is selected, the display will
show the time remaining in the program and your
current pace.
SPEED/INCLINE
display--This display
shows the speed"of the
walking belt and the
incline level of the tread-
mill. The display will
I $PE£DIINCI.INE i
o lit
change from one number to the other every seven
seconds. The INCL. indicator will light when the
incline level is shown.
Note: The console can measure speed in either
miles per hour or kilometers per hour. To check the
unit of measurement, first hold down the STOP/
PAUSE button while
inserting the key into the
console. Continue
holding the STOP/
PAUSE button for a
moment. An "E" (for
english miles) or an
"M" (for metric kilome-
ters) will appear in the
CALSJFAT CALSJ
CAl.& I FATCATS. I PUI.3E [
°1
1
PULSE display. To change the unit of measure-
ment, press the SPEED/k button. Remove and
then reinsert the key.
CALSJFAT CALS./
PULSE display--When
the chest pulse sensor is
wom, this display shows
three numbers: the
approximate number of
CALS. I FAT CALS. I PUL_
'71
calodes you have bumed, the number of fat calories
you have burned, and your heart rate. The display
will change from one number to the next every
seven seconds. When the number of fat calories is
shown, the "fat" indicator beside the display will
light; when your heart rate is shown, the heart-
shaped indicator will flash with each heartbeat;
when the number of calories is shown, no indicator
will light. Note: If the chest pulse sensor is not
worn, the display will show on!y the numbers of
_ ._'- caiodes and fat calories burned.
DISTANCE/LAPS
display--This display
shows the distance that
you have walked and
the total number of 1/4-
mile laps you have
completed. The display will change from one num-
ber to the other even] seven seconds. The I_PS
indicator will light when the number of laps is
shown. Note: If the speed is shown in miles per
hour, the distance will be shown in miles; if the
speed is shown in kilometers per hour, the distan_
will be shown in kilometers. (See SPEED/INCLINi
display at the left.)
When you are finished exe='cising, stop the
walking belt and remove the key.
Step onto the foot rails and press the STOP/PAUSE
button. Next, change the incline of the treadmill
to 1.5%. The incline must be at 1.5% before the
treadmill is folded to the storage position or the
treadmill may be damaged. Remove the key from
the console. Store the key in a secure place. In
addition, press the on/off switch to the "off" position.
(See the drawing on page 11.)
13