Table of Contents
Advertisement
Installing the microphone (XAV-
W650BT/XAV-V630BT)
T)
To capture your voice during handsfree calling, you
need to install the microphone
.
Clip (not supplied)
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment are in your car, contact the store
where you purchased this unit, or the car dealer,
before installation.
Note
Before attaching the double-sided tape
surface of the dashboard with a dry cloth.
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings]
[User Defined] to make the
.
registration (page 19).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 19).
Using the rearview camera
Installation of the rearview camera (not supplied) is
required before use.
The image of a rearview camera connected to the
CAMERA IN terminal is displayed when:
the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
you press HOME, then touch [Rear Camera].
you press and hold DSPL then touch [Rear
Camera] if [SOURCE Key Func.] is set to [DSPL]
Installation
Mounting the unit in the dashboard
When mounting in a Japanese car, see "Mounting
the unit in a Japanese car" (page 37).
Mounting the unit with an installation kit
(not supplied)
Before installing, make sure the catches on both
sides of the bracket are bent inwards 3.5 mm (
in).
1
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
Bracket
2
Mount the unit onto the bracket.
, clean the
Note
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.
.
Bracket
Parts supplied with your
car
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws
the appropriate screw holes based on your car: T
for TOYOTA, M for MITSUBISHI and N for NISSAN.
.
Note
To prevent a malfunction, install only with the supplied
screws
.
Fuse replacement
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse. If
the fuse blows, check the power
connection and replace the fuse. If
.
the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
5
/
32
Larger than
Catch
182 mm (7
1
/
in)
4
Larger than
111 mm (4
3
/
in)
8
Bracket
To the dashboard/center console
Bracket
in
XAV-W600/W650BT
Fuse (10 A)
19
Advertisement
Table of Contents
