LINOVISION POE-SW806GM-Solar User Manual page 10

2 Down Panel
Reset
1. V1 V2:DC Input
The solar POE switch can also be used as an ordinary switch, when the power input such as the
battery solar panel is not connected. V1, V2 any interface DC input 12-37V, the current maximum
10A, the device is a Ethernet switch; V1, V2 any interface DC input 37-57V, the current maximum
10A, the device is a POE switch. If both V1 and V2 ports supply power at the same time, select
the port with the highest voltage.
2. LED Indicators description
LED Indicators
BT:Battery
VOT:PoE Voltage normal
BOUT: Battery discharge
SUN: Solar energy input
BIN: Battery charging
Battery percentage
Alarm Output Temperature
Terminal Sensor Input
DIP Switch Battery and Solar LED
Status Description
On Battery is connected
Off Battery is disconnected
On PoE Voltage normal
Off PoE Voltage abnormal
Solid on Battery is discharging and battery capacity is 15%
Off End of battery discharge or no discharge
Blink 1/2S: Battery capacity is ≤15%
Solid on Solar energy input is normal
Off No solar energy input
1/2S: Solar energy is in delayed charging, the time is 10mins.
Blink
1/4S: Solar power voltage is wrong, stop charging
Solid on Battery is charging and battery capacity is <98%
Off Battery is charged fully or no charging
Blink The battery is charging, and battery capacity is ≥98%
Solid on Reference the battery capacity 25% 50% 75% 100%
V1 V2: DC Input
Indicators
Grounding
Alarm Input
Terminal