Advertisement
Set-up Instructions
1. Unpacking and Placement:
Caution: Do not plug the machine into the mains or turn it on during set-up.
Carefully unpack the machine and accessories. Place the machine on an even,
stable surface, ensuring there are no flammable materials nearby as the heater
bands can reach temperatures of up to 600°C.
2. Hopper Attachment:
Begin by attaching the hopper. Locate two bolts in the barrel's designated holes.
Unscrew these bolts, position the hopper over the holes, and securely screw the
bolts back in place.
3. Optional 45-Degree Angle Set-up:
The extruder can be used flat on an even surface or at a 45-degree angle using
the provided mounting brackets. Secure the brackets with the six bolts provided:
two for each end and two connecting the brackets. Note: When in the angled
position, ensure the machine is properly secured to prevent accidental tipping.
4. Power Connection:
Once the initial steps are completed, you can plug in the mains cable into the
machine. Before doing so, double-check that the mains voltage (e.g., 220VAC or
110VAC) matches the voltage specified on the machine (refer to the sticker on the
machine).
Note: Always follow these set-up instructions meticulously to ensure the safe and
effective operation of the machine. If you encounter any issues or have
questions, refer to the comprehensive user manual for further guidance.
7
Advertisement
