Haworth Zody LX User Manual

Seat Height Adjustment

1
Seat height adjustment lets you adjust the chair to
properly position your body at the worksurface and
maintain proper blood flow in your legs. Seat height
should be adjusted to allow your legs to maintain a
90-degree angle to the floor or footrest. (1)Pull up on
the lever and raise your body out of the chair to increase
seat height. (2) Stay in the chair and pull up on the lever
to decrease seat height.

Seat Depth Adjustment

2
Seat depth adjustment moves the seat pad to accommo-
date different leg lengths. It helps you sit back far enough
in the chair to use the backrest without creating pressure
behind the knees. With a full 76 mm of seat depth you
have lots of room to adjust, so blood flow to your legs
isn't restricted and you stay alert. (1) Pull up and slide
the seat forward to lengthen, or backward to shorten. A
minimum of two fingers should fit between the back of
your calf and the front of the seat.

Tilt Tension Control

3
Regulates the amount of resistance you feel when
leaning back in the chair, and the effort required to
recline backward. You accomplish multiple tasks
throughout the day—the tension control helps you
stay comfortable. (1) Turn the crank forward to
increase tension; backward to decrease.
4

Back Stop and Forward Tilt

Back stop lets you select an upright position or limit
the amount of recline while performing different
tasks. Back stops in 6 positions - upright and every
4° backward. Rotate the lever forward to engage;
rotate backward to disengage.
Forward Tilt enables you to vary your posture
throughout the day by changing the curve of your
spine. (1)Push down on the lever. (2)Recline just
until you hear a click, then lean forward. (3) Pull up
on lever and lean back to release forward tilt.
Fully Retracted
Back Stop & Lever Clicks
"Sync-Up"
Activate
1
Zody LX
User Guide
127 mm
406 mm
Fully Extended
76 mm
(+)
(-)
Release
2
533 mm
Page 1|2