Haworth Zody II User Manual

Seat Height Adjustment

1
Seat height adjustment lets you adjust the chair to
properly position your body at the worksurface and
maintain proper blood flow in your legs. Seat height
should be adjusted to allow your legs to maintain a
90-degree angle to the floor or footrest. (1)Pull up on the
lever and raise your body out of the chair to increase seat
height. (2) Stay in the chair and pull up on the lever to
decrease seat height.

Seat Depth Adjustment

2
Seat depth adjustment moves the seat pad to accommodate
different leg lengths. It helps you sit back far enough in the
chair to use the backrest without creating pressure behind
the knees. With a full 76 mm of seat depth you have lots of
room to adjust, so blood flow to your legs isn't restricted
and you stay alert. (1) Pull up and slide the seat forward to
lengthen, or backward to shorten. A minimum of two
fingers should fit between the back of your calf and the
front of the seat.

Tilt Tension Control

3
Regulates the amount of resistance you feel when leaning
back in the chair, and the effort required to recline
backward. You accomplish multiple tasks throughout the
day—the tension control helps you stay comfortable. (1)
Turn the crank forward to increase tension; backward to
decrease.

Back Stop and Forward Tilt

4
Back stop lets you select an upright position or limit the
amount of recline while performing different tasks.
Back stops in 6 positions - upright and every 4°backward.
Rotate the lever forward to engage; rotate backward to
disengage.
Forward Tilt enables you to vary your posture throughout
the day by changing the curve of your spine. (1)Push down
on the lever. (2)Recline just until you hear a click, then lean
forward. (3) Pull up on lever and lean back to release
forward tilt.
Fully Retracted
Back Stop & Lever Clicks
"Sync-Up"
Activate
1
Zody II
User Guide
127 mm
533 mm
406 mm
Fully Extended
76 mm
(+)
(-)
Release
2
Page 1|2