Infineon CY7113 EZ-PD PMG1-S3 Quick Start Manual

Quick start guide
CY7113 EZ-PD™ PMG1-S3 prototyping kit
The CY7113 EZ-PD™ PMG1-S3 prototyping kit is a development platform to design products which can be
powered from a high-voltage USB PD port, and also need a microcontroller with CAPSENSE™ capability to
implement different applications. This platform is compliant with the USB PD 3.0 protocol and can support
up to 100 W (20 V, 5A) of power consumption. It also supports two self-capacitance-based CAPSENSE™
buttons and one 5-segment slider.
EZ-PD™ PMG1-S3
CAPSENSE™ buttons(CSB1, CSB2)
and feedback LEDs (LED5, LED6)
3V3
VDDIO_IN
GND
CC1
CC2
LED3_IN
SW2_IN
RESET
P3.5/UART_RX
P3.6/UART_TX
P3.3
P3.0
P2.3
P2.4
P2.2
P2.1
P5.2
GND
P5.3
P5.5
KitProg3
www.cypress.com/CY7113
Arrow.com.
Downloaded from
Reset switch (SW3)
User switch (SW2)
DC_OUT terminal block (J9)
Power LED (LED4)
J6
KitProg3 VBUS LED (LED2)
KitProg3 USB Type-C port (J1)
EZ-PD™ PMG1-S3 microcontroller (U3)
Power selection jumper (J5)
User LED (LED3)
EZ-PD™ PMG1-S3 USB PD sink port (J10)
CAPSENSE™ slider (CSS1) and
feedback LEDs (LED7 – LED11)
J7
KitProg3 mode switch (SW1)
KitProg3 status LED (LED1)
VDDD
VCONN_SRC
GND
P1.5
P1.6
P4.1/I2C_SDA
P4.0/I2C_SCL
P1.4
P1.3
P6.3
P6.2
P0.0
P6.1
P6.0
GND
P1.2/SWD_IO
P1.1/SWD_CLK
VSYS_IN
P5.0
P5.1