Maintenance - Kelvinator KCICDC4FH Operator's Manual

OPERATION
CONTROL PANEL
Electronic Thermostat
1. The EMS is electronic controller.
2. The electronic controller has been already set in the factory.
3. If you need to adjust the electronic controller, please contact professional
service personnel.
STORAGE
1. The appliance is suitable for storing ice cream and ready-frozen foods.
2. It must not be filled higher than the stacking mark on the inside of the showcase.
3. If there is no load line sticker, please take the top of placed basket as standard.
LOAD LINE
DEFROST
1. Defrost when the frost thickness on the wall of the cabinet reaches 5mm to
optimize the freezing capacity.
2. Turn the temperature control to the lowest point for 5-6 hours before defrosting.
3. Cut off the power and take out the food, use the defrost removal, do not apply
sharp tools.
4. After defrosting, clean the wall with dry cloth, and then power on.
THE FOLLOWING PHENOMENA ARE NORMAL
1. There will be sound of flowing water when the refrigerant is running.
2. The frozen food do not melt even if a long time power off.
3. When the environment humidity is too high, there will be dew condensed on the
surface of the showcase.
4. When the machine is running, the condenser and compressor will be hot.
LOCK
3 OM-DIPPING CABINET
1. You can lock the freezer: First step you put the key and key cylinder into lock hole;
2． You can unlock the freezer: First step you turn the key rotate 90° CCW; The
NOTES: The lock is one of the options your product may not have.
KCICDC4FH
KCICDC6FH

MAINTENANCE

KCICDC8FH
1. Do not open the door frequently or for too long to save energy.
KCICDC10FH
2. Never leave heavy or hot stuff on the top of the showcase to avoid deforming.
3. Cut off the power before cleaning.
4. To clean the showcase, please use soft cloth dampened in some moderate
5. Use warm water to clean oil or fruit juice stain on the magnetic gasket in order
6. The showcase should not be left unused for a long time, to stop using the
CORRECT DISPOSAL OF THIS PRODUCT
REPLACEMENT PARTS
To order parts, contact your Authorized Service Agent. Supply the model
designation, serial number, part description, part number, quantity, and when
applicable, voltage and phase.
CONTACT US
In order to obtain service the unit must first be registered at Kelvinator Commercial.
com. Once registered please call 866-339-8515 for assistance.
The second step you turn the key rotate 90° CW; Then you put out the key.
second step you put out the key and key cylinder from lock hole.
detergent and hot water.
to keep its elasticity. Apply some talcum powder to it to prolong its service life.
showcase, disconnect the main power first, then clean the inside and leave
the door open for 2-3 days to dry it.
This marking indicates that this product should not be
disposed with other household wastes. To prevent possible
harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used
device, please use the return and collection systems or
contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.